At Ananka Fasteners Pvt Ltd, we manufacture fasteners to the dimensional requirements of DIN 6912. Hexagon socket head cap screws with low head and a centre pilot/guide recess. Reduced head height (roughly half of DIN 912) for tight clearance applications; a small guide (pilot) bore in the head centre. Uses a smaller hex key than the equivalent DIN 912. Thread M3-M20, coarse pitch.
Hexagon socket head cap screws with low head and a centre pilot/guide recess. Reduced head height (roughly half of DIN 912) for tight clearance applications; a small guide (pilot) bore in the head centre. Uses a smaller hex key than the equivalent DIN 912. Thread M3-M20, coarse pitch.
low-head hex socket cap screw with pilot
Key dimensions for common sizes are listed below.
| Size | Head dia dk (mm) | Head height k (mm) | Hex socket key s (mm) |
|---|---|---|---|
| M3 | 7.0 | 2.8 | 2.5 |
| M4 | 7.0 | 2.8 | 3.0 |
| M5 | 8.5 | 3.5 | 4.0 |
| M6 | 10.0 | 4.0 | 5.0 |
| M8 | 13.0 | 5.0 | 6.0 |
| M10 | 16.0 | 6.5 | 8.0 |
| M12 | 18.0 | 7.5 | 10.0 |
| M16 | 24.0 | 10.0 | 14.0 |
| M20 | 30.0 | 12.0 | 17.0 |
6g
[‘DIN 912’, ‘DIN 7984’, ‘ISO 4762’, ‘ISO 14580’]
For the official DIN standards catalogue, see the DIN standards listing. This external reference is provided for standards identification; the purchaser should verify the current edition applicable to the order.
We produce DIN 6912 fasteners in carbon and alloy steel, austenitic, duplex and super-duplex stainless, and high-nickel, titanium and copper alloys — for structural, flanged, machinery and process applications worldwide.
For technical documentation and quotations, buyers can also review the Ananka Fasteners manufacturing and supply range or contact the team through the fastener enquiry and technical support page.
Ananka Fasteners supplies every lot with full material traceability and third-party testing on request.
Hexagon socket head cap screws with low head and a centre pilot/guide recess. Reduced head height (roughly half of DIN 912) for tight clearance applications; a small guide (pilot) bore in the head centre. Uses a smaller hex key than the equivalent DIN 912. Thread M3-M20, coarse pitch.
Ananka Fasteners manufactures DIN 6912 in sizes from M3–M20. See the Dimensional Table above for the complete size breakdown.
6g
We produce DIN 6912 fasteners in carbon and alloy steel, austenitic, duplex and super-duplex stainless, and high-nickel, titanium and copper alloys — for structural, flanged, machinery and process applications worldwide.
Yes. For a quotation, provide the required nominal size, material grade, quantity and any inspection or certificate requirements.
Need a fastener manufactured to DIN 6912 for an industrial project? Send the required fastener type, size, material grade, quantity and certification requirements to Ananka Fasteners. Our team can review the requirement and provide technical and commercial information for standard or custom configurations.
Recommended RFQ details: DIN 6912 requirement, nominal size, material grade, quantity, inspection requirements and EN 10204 certificate requirements where applicable.
Dimensions compiled per DIN 6912 and industry references; provided for reference only — confirm against the current edition of the standard before design use.
