At Ananka Fasteners Pvt Ltd, we manufacture and supply fasteners certified to ASTM A489. Standard specification for carbon steel eyebolts (formerly ‘lifting eyes’). Covers forged carbon steel eyebolts for overhead lifting, defining working load limits, proof-load and ultimate-load performance rather than a single tensile table.
Standard specification for carbon steel eyebolts (formerly ‘lifting eyes’). Covers forged carbon steel eyebolts for overhead lifting, defining working load limits, proof-load and ultimate-load performance rather than a single tensile table.
| Grade / Class | UNS / Designation | Type / Notes |
|---|---|---|
| Carbon steel eyebolt | – | Forged carbon steel, single class; sized by nominal shank diameter |
Minimum mechanical requirements per ASTM A489.
| Grade / Class / Condition | Tensile Strength, min | Yield Strength, min | Elongation, min % | Hardness |
|---|---|---|---|---|
| All sizes (proof) | Must sustain proof load = 2x rated working load with no permanent set | – | – | – |
| All sizes (ultimate) | Min ultimate load = 5x rated working load | – | – | – |
| Grade | Key Composition, % |
|---|---|
| Carbon steel | Low/medium carbon steel suitable for forging (e.g. AISI 1030-class); specific ladle limits per manufacturer/spec |
Performance/dimensional companion to ASME B18.15 eyebolts; working-load approach similar to ASTM A952 (forged eye nuts/eye bolts).
For the official ASTM International standards catalogue, see the ASTM International standards listing. This external reference is provided for standards identification; the purchaser should verify the current edition applicable to the order.
We supply ASTM A489 fasteners — bolts, screws, studs, nuts and washers as applicable — for energy, petrochemical, marine, structural and general engineering service, in a full range of sizes and finishes.
For technical documentation and quotations, buyers can also review the Ananka Fasteners manufacturing and supply range or contact the team through the fastener enquiry and technical support page.
Ananka Fasteners supplies every lot with full material traceability and third-party testing on request.
Standard specification for carbon steel eyebolts (formerly ‘lifting eyes’). Covers forged carbon steel eyebolts for overhead lifting, defining working load limits, proof-load and ultimate-load performance rather than a single tensile table.
Ananka Fasteners supplies Carbon steel eyebolt to ASTM A489. See the Grades / Classes Covered table above for full details of each grade.
Minimum tensile strength, yield strength, elongation and hardness requirements vary by grade — see the Mechanical Properties table above for the complete breakdown.
We supply ASTM A489 fasteners — bolts, screws, studs, nuts and washers as applicable — for energy, petrochemical, marine, structural and general engineering service, in a full range of sizes and finishes.
Yes. For a quotation, provide the required fastener type, grade, nominal size, dimensional standard, quantity and any inspection or certificate requirements.
Need a fastener released to ASTM A489 for an industrial project? Send the required fastener type, grade, size, quantity and certification requirements to Ananka Fasteners. Our team can review the requirement and provide technical and commercial information for standard or custom configurations.
Recommended RFQ details: ASTM A489 requirement, material grade, fastener type, nominal size, dimensional standard, quantity, inspection requirements and EN 10204 certificate requirements where applicable.
Data compiled per ASTM A489 and industry references; provided for reference only — confirm against the current edition of the standard and certified mill test reports before design use.
