At Ananka Fasteners Pvt Ltd, we manufacture fasteners to the dimensional requirements of DIN 11014. DIN 11014 (agricultural equipment) covers flat countersunk (double-nib / two-nib) plough bolts with matching nuts, used on ploughs, tillage tools and earthmoving wear parts. The flat countersunk head carries two nibs on the underside that seat into a matching sinking to prevent rotation. Sizes are limited and coarse (typically M12-M24). Representative values below; exact head and nib geometry vary by the 1968 sheet.
DIN 11014 (agricultural equipment) covers flat countersunk (double-nib / two-nib) plough bolts with matching nuts, used on ploughs, tillage tools and earthmoving wear parts. The flat countersunk head carries two nibs on the underside that seat into a matching sinking to prevent rotation. Sizes are limited and coarse (typically M12-M24). Representative values below; exact head and nib geometry vary by the 1968 sheet.
Flat countersunk head plough bolt with two nibs (double-nib), with nut
Key dimensions for common sizes are listed below.
| Thread d | Head dia dk (mm) | Head height k (mm) | Nib spacing (mm) |
|---|---|---|---|
| M12 | 30 | 6.5 | 18 |
| M14 | 34 | 7.5 | 21 |
| M16 | 38 | 8.5 | 24 |
| M20 | 46 | 10.5 | 30 |
| M22 | 50 | 11.5 | 34 |
| M24 | 54 | 12.5 | 36 |
6g external thread
[‘DIN 604’, ‘DIN 605’, ‘DIN 608’, ‘DIN 11015’]
For the official DIN standards catalogue, see the DIN standards listing. This external reference is provided for standards identification; the purchaser should verify the current edition applicable to the order.
We produce DIN 11014 fasteners in carbon and alloy steel, austenitic, duplex and super-duplex stainless, and high-nickel, titanium and copper alloys — for structural, flanged, machinery and process applications worldwide.
For technical documentation and quotations, buyers can also review the Ananka Fasteners manufacturing and supply range or contact the team through the fastener enquiry and technical support page.
Ananka Fasteners supplies every lot with full material traceability and third-party testing on request.
DIN 11014 (agricultural equipment) covers flat countersunk (double-nib / two-nib) plough bolts with matching nuts, used on ploughs, tillage tools and earthmoving wear parts. The flat countersunk head carries two nibs on the underside that seat into a matching sinking to prevent rotation. Sizes are limited and coarse (typically M12-M24). Representative values below; exact head and nib geometry vary by the 1968 sheet.
Ananka Fasteners manufactures DIN 11014 in sizes from M12–M24. See the Dimensional Table above for the complete size breakdown.
6g external thread
We produce DIN 11014 fasteners in carbon and alloy steel, austenitic, duplex and super-duplex stainless, and high-nickel, titanium and copper alloys — for structural, flanged, machinery and process applications worldwide.
Yes. For a quotation, provide the required nominal size, material grade, quantity and any inspection or certificate requirements.
Need a fastener manufactured to DIN 11014 for an industrial project? Send the required fastener type, size, material grade, quantity and certification requirements to Ananka Fasteners. Our team can review the requirement and provide technical and commercial information for standard or custom configurations.
Recommended RFQ details: DIN 11014 requirement, nominal size, material grade, quantity, inspection requirements and EN 10204 certificate requirements where applicable.
Dimensions compiled per DIN 11014 and industry references; provided for reference only — confirm against the current edition of the standard before design use.
